RibIt GreenTM Universal Flashing − Installation

Ribit Green Flashing Tape Stays Stuck Construction worker applying Ribit Green Flashing Tape to seal window

Very similar procedures are followed to apply RibIt Green UniversalTM flashing to vinyl, concrete, plywood and metal substrates. The following procedure can be used to flash all seams, angle changes and details. Procedures and materials vary by substrate, cover material to be applied and flashed component system manufacturer.

  1. Cut RibIt Green UniversalTM neoprene to extend at least 1! inches on each side of the detail (joint, angle change, flashing, etc.). Neoprene material is highly elastic. It can be fitted around pipes and the insides and outsides of corners
  2. Clean and prep surface and/or apply primer as needed. Ultimate adhesion performance is obtained when surface is properly prepared
  3. Apply RibIt Green UniversalTM neoprene over the seam, angle change or detail being careful to avoid leaving air bubbles or creases
  4. Use a handheld roller to marry the neoprene to the substrate
  5. For window applications and when cold fluid-applied coatings will be applied over neoprene, apply manufacturer-approved caulk to the edges of installed neoprene strips and feather, or tool down the caulk where the neoprene sheet edge intersects window frame


Better Business Bureau
A+ Rating